銅含量測試劑 Salifert Cu

銅含量測試劑

銅通常用作治療受寄生蟲感染的魚類，因此必須使用正確的濃度，因為過高的濃度可能對海洋魚類和無脊椎動物有毒。

• Salifert 檢測試劑足以進行 50-100 次測試。
• 可用於海水、淡水和花園池塘水
• 只能檢測出部分或完全檢測不到螯合銅

使用方法：

1. 在測試瓶中加入2ml的水
2. 加入5滴Cu試劑並輕輕搖動測試液5秒鐘。
3. 將測試液靜置10分鐘。注意，強烈結合的銅可能需要20分鐘的等待時間。因此可以對比靜置10分鐘和20分鐘後的結果，能反映到銅含量的最高值。
4. 請將靜置結束後的測試瓶置於顏色卡的白色部分，然後從瓶的側面觀察測試液。

Salifert Cu

Copper is often used as a treatment for parasite infested fish and it is essential that the correct concentration is used as too high levels can be toxic to marine fish and invertebrates.

• Lasts for several copper cures or provides sufficient for up to 50 tests on tap or aquarium water as a routine check.
• Ca be used for marine, fresh and garden pond water
• Strongly chelated copper will only be partly or not at all detected

Instructions:

1. Add 2ml of water in the test vial.
2. Add 5 drops of the Cu reagent and swirl gently for 5 seconds.
3. Allow it to stand for 10 minutes. Some copper medications might use strongly bound copper and would require a waiting time of 20 minutes. In case of doubt compare the value after 10 and 20 minutes of waiting. The highest value should be noted.
4. 
   
5. To obtain the copper concentration hold the test vial in front of you. Place the white part of the color chart firmly against the side of the test vial and look from the opposite side.